/* * CDDL HEADER START * * The contents of this file are subject to the terms of the * Common Development and Distribution License (the "License"). * You may not use this file except in compliance with the License. * * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE * or http://www.opensolaris.org/os/licensing. * See the License for the specific language governing permissions * and limitations under the License. * * When distributing Covered Code, include this CDDL HEADER in each * file and include the License file at usr/src/OPENSOLARIS.LICENSE. * If applicable, add the following below this CDDL HEADER, with the * fields enclosed by brackets "[]" replaced with your own identifying * information: Portions Copyright [yyyy] [name of copyright owner] * * CDDL HEADER END */ /* * Copyright 2006 Sun Microsystems, Inc. All rights reserved. * Use is subject to license terms. */ #ifndef _SYS_USB_HIDVAR_H #define _SYS_USB_HIDVAR_H #pragma ident "%Z%%M% %I% %E% SMI" #ifdef __cplusplus extern "C" { #endif #include /* * HID : This header file contains the internal structures * and variable definitions used in hid driver. */ /* * HID USB device state management : * * ONLINE-----1--->SUSPENDED----2---->ONLINE * | * +-----3--->DISCONNECTED----4----->ONLINE * | * +-----7--->POWERED DOWN----8----->POWER CHANGE---9--->ONLINE * | * +---3--->DISCONNECTED * * POWERED DOWN----1--->SUSPENDED------2----->POWERED DOWN * | | ^ * | 5 | * | | 6 * | v | * +---------3----->DISCONNECTED-------4----->POWERED DOWN * * 1 = CPR SUSPEND * 2 = CPR RESUME (with original device) * 3 = Device Unplug * 4 = Original Device Plugged in * 5 = CPR RESUME (with device disconnected or with a wrong device) * 6 = CPR SUSPEND on a disconnected device * 7 = Device idles for time T & transitions to low power state * 8 = Remote wakeup by device OR Application kicking off IO to device * This results in a Transistion state till PM calls the power * entry point to raise the power level of the device * 9 = Device entry point called to raise power level of the device * */ /* Boot protocol values for keyboard and mouse */ #define KEYBOARD_PROTOCOL 0x01 /* legacy keyboard */ #define MOUSE_PROTOCOL 0x02 /* legacy mouse */ /* * If the hid descriptor is not valid, the following values are * used. */ #define USBKPSZ 8 /* keyboard packet size */ #define USBMSSZ 3 /* mouse packet size */ #define USB_KB_HID_DESCR_LENGTH 0x3f /* keyboard Report descr length */ #define USB_MS_HID_DESCR_LENGTH 0x32 /* mouse Report descr length */ /* * Flags for the default pipe. */ #define HID_DEFAULT_PIPE_BUSY 0x01 /* * Hid interrupt pipe states. Interrupt pipe * can be in only one of these states : * * open--1-->data_transferring--1-->open * | * |----2---->closed * * 1 = interrupt pipe callback * 2 = hid_close */ #define HID_INTERRUPT_PIPE_CLOSED 0x00 /* Int. pipe is closed */ #define HID_INTERRUPT_PIPE_OPEN 0x01 /* Int. pipe is opened */ /* HID mctl processing return codes */ #define HID_SUCCESS 0 /* mctl processed successfully */ #define HID_INPROGRESS 1 /* mctl queued/deferred for execution */ #define HID_ENQUEUE 2 /* mctl queued/deferred for execution */ #define HID_FAILURE -1 /* mctl processing failed */ /* Data is being sent up */ #define HID_INTERRUPT_PIPE_DATA_TRANSFERRING 0x03 /* Attach/detach states */ #define HID_LOCK_INIT 0x01 /* Initial attach state */ #define HID_MINOR_NODES 0x02 /* Set after minor node is created */ /* HID Protocol Requests */ #define SET_IDLE 0x0a /* bRequest value to set idle request */ #define DURATION (0<<8) /* no. of repeat reports (HID 7.2.4) */ #define SET_PROTOCOL 0x0b /* bRequest value for boot protocol */ /* Hid PM scheme */ typedef enum { HID_PM_ACTIVITY, /* device is power managed by idleness */ HID_PM_OPEN_CLOSE, /* device is busy on open, idle on close */ HID_PM_APPLICATION /* device is power managed by application */ } hid_pm_scheme_t; typedef struct hid_power { void *hid_state; /* points back to hid_state */ int hid_pm_busy; /* device busy accounting */ hid_pm_scheme_t hid_pm_strategy; /* device PM */ uint8_t hid_wakeup_enabled; /* this is the bit mask of the power states that device has */ uint8_t hid_pwr_states; /* wakeup and power transistion capabilites of an interface */ uint8_t hid_pm_capabilities; /* flag to indicate if driver is about to raise power level */ boolean_t hid_raise_power; /* current power level the device is in */ uint8_t hid_current_power; /* mblk indicating that the device has powered up */ mblk_t *hid_pm_pwrup; } hid_power_t; _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_power_t::hid_state)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_power_t::hid_pm_strategy)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_power_t::hid_wakeup_enabled)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_power_t::hid_pwr_states)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_power_t::hid_pm_capabilities)) typedef struct hid_state { dev_info_t *hid_dip; /* per-device info handle */ kmutex_t hid_mutex; /* for general locking */ int hid_instance; /* instance number */ minor_t hid_minor; boolean_t hid_km; /* for virtual keyboard/mouse */ ddi_taskq_t *hid_taskq; /* for physical access */ /* Attach/detach flags */ int hid_attach_flags; /* device state flag */ int hid_dev_state; /* outstanding requests on the default pipe */ int hid_default_pipe_req; queue_t *hid_rq_ptr; /* pointer to read queue */ queue_t *hid_wq_ptr; /* pointer to write queue */ hid_power_t *hid_pm; /* ptr to power struct */ usb_client_dev_data_t *hid_dev_data; /* ptr to usb reg struct */ usb_dev_descr_t *hid_dev_descr; /* device descriptor. */ /* hid driver is attached to this interface */ int hid_interfaceno; usb_if_descr_t hid_if_descr; /* interface descr */ usb_hid_descr_t hid_hid_descr; /* hid descriptor */ usb_ep_descr_t hid_ep_intr_descr; hidparser_handle_t hid_report_descr; /* report descr */ usb_pipe_handle_t hid_default_pipe; /* default pipe */ usb_pipe_handle_t hid_interrupt_pipe; /* intr pipe handle */ int hid_streams_flags; /* see below */ int hid_packet_size; /* data packet size */ /* Pipe policy for the interrupt pipe is saved here */ usb_pipe_policy_t hid_intr_pipe_policy; /* * This field is only used if the device provides polled input * This is state information for the usba layer. */ usb_console_info_t hid_polled_console_info; /* * This is the buffer that the raw characters are stored in. * for polled mode. */ uchar_t *hid_polled_raw_buf; /* handle for outputting messages */ usb_log_handle_t hid_log_handle; } hid_state_t; /* warlock directives, stable data */ _NOTE(MUTEX_PROTECTS_DATA(hid_state_t::hid_mutex, hid_state_t)) _NOTE(MUTEX_PROTECTS_DATA(hid_state_t::hid_mutex, hid_power_t)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_dip)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_pm)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_dev_data)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_instance)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_km)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_minor)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_interrupt_pipe)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_ep_intr_descr)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_default_pipe)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_log_handle)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_if_descr)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_dev_data)) _NOTE(DATA_READABLE_WITHOUT_LOCK(hid_state_t::hid_dev_descr)) _NOTE(SCHEME_PROTECTS_DATA("stable data", hid_state_t::hid_rq_ptr)) _NOTE(SCHEME_PROTECTS_DATA("stable data", hid_state_t::hid_wq_ptr)) _NOTE(SCHEME_PROTECTS_DATA("stable data", usb_ep_descr)) /* * The hid_polled_console_info field is a handle from usba. The * handle is used when the kernel is in the single thread mode * so the field is tagged with this note. */ _NOTE(SCHEME_PROTECTS_DATA("unique per call", hid_state_t::hid_polled_console_info)) /* * structure for argument for callback routine for async * data transfer through default pipe. */ typedef struct hid_default_pipe_argument { /* Message to be sent up to the stream */ struct iocblk hid_default_pipe_arg_mctlmsg; /* Pointer to hid_state structure */ hid_state_t *hid_default_pipe_arg_hidp; /* Pointer to the original mblk_t received from hid_wput() */ mblk_t *hid_default_pipe_arg_mblk; /* Request that caused this callback to happen */ uchar_t hid_default_pipe_arg_bRequest; } hid_default_pipe_arg_t; /* * An instance of this structure is created per command down to the * device. The control callback is not executed until the call is * made into usba, so there is no danger of a callback happening when * the fields of the structure are being set. */ _NOTE(SCHEME_PROTECTS_DATA("unique per call", hid_default_pipe_arg_t)) /* * An instance of this structure is created per command down to the * device. The callback is not executed until the call is * made into usba, so there is no danger of a callback happening when * the fields of the structure are being set. */ /* Value for hid_streams_flags */ #define HID_STREAMS_OPEN 0x00000001 /* Streams are open */ #define HID_STREAMS_DISMANTLING 0x00000002 /* In hid_close() */ #define HID_BAD_DESCR 0x01 /* Bad hid report descriptor */ #define HID_MINOR_NAME_LEN 20 /* Max length of minor_name string */ /* hid_close will wait 60 secons for callbacks to be over */ #define HID_CLOSE_WAIT_TIMEOUT 10 /* define a timeout for draining requests on the default control pipe */ #define HID_DEFAULT_PIPE_DRAIN_TIMEOUT 5 /* To support PM on SUN mice of later revisions */ #define HID_SUN_MOUSE_VENDOR_ID 0x0430 #define HID_SUN_MOUSE_PROD_ID 0x0100 #define HID_SUN_MOUSE_BCDDEVICE 0x0105 /* and later revisions */ /* * Debug message Masks */ #define PRINT_MASK_ATTA 0x00000001 #define PRINT_MASK_OPEN 0x00000002 #define PRINT_MASK_CLOSE 0x00000004 #define PRINT_MASK_EVENTS 0x00000008 #define PRINT_MASK_PM 0x00000010 #define PRINT_MASK_ALL 0xFFFFFFFF /* * Define states local to hid driver */ #define USB_DEV_HID_POWER_CHANGE 0x80 /* define for retrying control requests */ #define HID_RETRY 10 #ifdef __cplusplus } #endif #endif /* _SYS_USB_HIDVAR_H */