/* * Copyright 2005 Sun Microsystems, Inc. All rights reserved. * Use is subject to license terms. */ /* * Copyright (c) 1983 Regents of the University of California. * All rights reserved. The Berkeley software License Agreement * specifies the terms and conditions for redistribution. */ /* * Routines for calling up on a Ventel Modem * Define VENNOECHO if the Ventel is strapped for "no echo". */ #include "tip.h" #define MAXRETRY 5 static int vensync(int); static int gobble(char); static void echo(char *); static void sigALRM(void); static int timeout = 0; static sigjmp_buf timeoutbuf; void ven_disconnect(void); /* ARGSUSED */ int ven_dialer(char *num, char *acu) { char *cp; int connected = 0; struct termios buf; #ifdef ACULOG char line[80]; #endif /* * Get in synch with a couple of carriage returns */ if (!vensync(FD)) { (void) printf("can't synchronize with ventel\n"); #ifdef ACULOG logent(value(HOST), num, "ventel", "can't synch up"); #endif return (0); } if (boolean(value(VERBOSE))) (void) printf("\ndialing..."); (void) fflush(stdout); (void) ioctl(FD, TCGETS, &buf); buf.c_cflag |= HUPCL; (void) ioctl(FD, TCSETSF, &buf); #ifdef VENNOECHO echo("#k$\r$\n$D$I$A$L$:$ "); for (cp = num; *cp; cp++) { (void) sleep(1); (void) write(FD, cp, 1); } echo("\r$\n"); #else echo("k$\r$\n$D$I$A$L$:$ <"); for (cp = num; *cp; cp++) { char c; (void) sleep(1); (void) write(FD, cp, 1); (void) read(FD, &c, 1); } echo(">\r$\n"); #endif if (gobble('\n')) connected = gobble('!'); (void) ioctl(FD, TCFLSH, TCIOFLUSH); #ifdef ACULOG if (timeout) { (void) sprintf(line, "%d second dial timeout", number(value(DIALTIMEOUT))); logent(value(HOST), num, "ventel", line); } #endif if (timeout) ven_disconnect(); /* insurance */ return (connected); } void ven_disconnect(void) { (void) close(FD); } void ven_abort(void) { (void) write(FD, "\03", 1); (void) close(FD); } static void echo(char *s) { char c; while (c = *s++) { switch (c) { case '$': (void) read(FD, &c, 1); s++; break; case '#': c = *s++; (void) write(FD, &c, 1); break; default: (void) write(FD, &c, 1); (void) read(FD, &c, 1); } } } static void sigALRM(void) { (void) printf("\07timeout waiting for reply\n"); timeout = 1; siglongjmp(timeoutbuf, 1); } static int gobble(char match) { char c; sig_handler_t f; f = signal(SIGALRM, (sig_handler_t)sigALRM); timeout = 0; do { if (sigsetjmp(timeoutbuf, 1)) { (void) signal(SIGALRM, f); return (0); } (void) alarm(number(value(DIALTIMEOUT))); (void) read(FD, &c, 1); (void) alarm(0); c &= 0177; #ifdef notdef if (boolean(value(VERBOSE))) (void) putchar(c); #endif } while (c != '\n' && c != match); (void) signal(SIGALRM, SIG_DFL); return (c == match); } #define min(a, b) (((a) > (b)) ? (b) : (a)) /* * This convoluted piece of code attempts to get * the ventel in sync. If you don't have FIONREAD * there are gory ways to simulate this. */ static int vensync(int fd) { int already = 0, nread; char buf[60]; int dtr = TIOCM_DTR; /* * Toggle DTR to force anyone off that might have left * the modem connected, and insure a consistent state * to start from. * * If you don't have the ioctl calls to diddle directly * with DTR, you can always try setting the baud rate to 0. */ (void) ioctl(FD, TIOCMBIC, &dtr); (void) sleep(2); (void) ioctl(FD, TIOCMBIS, &dtr); while (already < MAXRETRY) { /* * After reseting the modem, send it two \r's to * autobaud on. Make sure to delay between them * so the modem can frame the incoming characters. */ (void) write(fd, "\r", 1); #ifdef VMUNIX { #include struct timeval tv = {0, 500000}; (void) select(0, 0, 0, 0, &tv); } #else (void) sleep(1); #endif (void) write(fd, "\r", 1); (void) sleep(3); if (ioctl(fd, FIONREAD, (caddr_t)&nread) < 0) { perror("tip: ioctl"); continue; } while (nread > 0) { (void) read(fd, buf, min(nread, 60)); if ((buf[nread - 1] & 0177) == '$') return (1); nread -= min(nread, 60); } (void) sleep(1); already++; } return (0); }