Lines Matching refs:pp
235 #define USBSER_PORT_ACCESS_OK(pp) ((pp)->port_state == USBSER_PORT_OPEN) argument
240 #define USBSER_PORT_IS_BUSY(pp) ((pp)->port_act != 0) argument
243 #define USBSER_PORT_IS_BUSY_NON_RX(pp) \ argument
244 (((pp)->port_act & (USBSER_ACT_DELAY | USBSER_ACT_CTL | \
250 #define USBSER_IS_OPENING(pp) \ argument
251 (((pp)->port_state == USBSER_PORT_OPENING_TTY) || \
252 ((pp)->port_state == USBSER_PORT_OPENING_OUT))
258 #define USBSER_NO_OTHER_OPEN(pp, minor) \ argument
260 ((pp)->port_state == USBSER_PORT_OPENING_OUT)) || \
261 (!((minor) & OUTLINE) && ((pp)->port_state == USBSER_PORT_OPENING_TTY)))
267 #define USBSER_OPEN_IN_OTHER_MODE(pp, minor) \ argument
268 ((((minor) & OUTLINE) && !((pp)->port_flags & USBSER_FL_OUT)) || \
269 (!((minor) & OUTLINE) && ((pp)->port_flags & USBSER_FL_OUT)))
355 #define USBSER_DS_SET_PORT_PARAMS(pp, params) \ argument
356 pp->port_ds_ops->ds_set_port_params(pp->port_ds_hdl, pp->port_num, \
359 #define USBSER_DS_SET_MODEM_CTL(pp, mask, val) \ argument
360 pp->port_ds_ops->ds_set_modem_ctl(pp->port_ds_hdl, pp->port_num, mask, \
363 #define USBSER_DS_GET_MODEM_CTL(pp, mask, valp) \ argument
364 pp->port_ds_ops->ds_get_modem_ctl(pp->port_ds_hdl, pp->port_num, \
367 #define USBSER_DS_BREAK_CTL(pp, val) \ argument
368 pp->port_ds_ops->ds_break_ctl(pp->port_ds_hdl, pp->port_num, val)
370 #define USBSER_DS_LOOPBACK(pp, val) \ argument
371 pp->port_ds_ops->ds_loopback(pp->port_ds_hdl, pp->port_num, val)
374 #define USBSER_DS_TX(pp, mp) \ argument
375 pp->port_ds_ops->ds_tx(pp->port_ds_hdl, pp->port_num, mp)
377 #define USBSER_DS_RX(pp) \ argument
378 pp->port_ds_ops->ds_rx(pp->port_ds_hdl, pp->port_num)
380 #define USBSER_DS_STOP(pp, dir) \ argument
381 pp->port_ds_ops->ds_stop(pp->port_ds_hdl, pp->port_num, dir)
383 #define USBSER_DS_START(pp, dir) \ argument
384 pp->port_ds_ops->ds_start(pp->port_ds_hdl, pp->port_num, dir)
387 #define USBSER_DS_FIFO_FLUSH(pp, mask) \ argument
388 pp->port_ds_ops->ds_fifo_flush(pp->port_ds_hdl, pp->port_num, mask)
390 #define USBSER_DS_FIFO_DRAIN(pp, tmout) \ argument
391 pp->port_ds_ops->ds_fifo_drain(pp->port_ds_hdl, pp->port_num, tmout)
395 #define USBSER_DS_LOOPBACK_SUPPORTED(pp) (pp->port_ds_ops->ds_loopback != 0) argument